Here I am outside in my backyard spraying the completed body of the DR-1 with Krylon to harden the tissue. I attached the rubber band used to make the propeller spin to a coat hanger to make it easier to spray.
Sunday, June 27, 2010
Thursday, June 24, 2010
Friday, June 18, 2010
The landing strut proved to be very complicated to cover with tissue due to the landing strut sticking out of the fourth wing. All I can say is that a bit of patience and a lot of cutting did the trick in completing this section of the aircraft. Despite being a hard piece to work with the challenge made it fun sub assembly to work on.
Saturday, June 12, 2010
After a lot of research and testing several techniques, I came to the conclusion that the best method to cover the plane was to use a simple glue stick with tissue paper and spray it with fine particles of water then apply in a spray can Krylon clear finish. I tried the traditional technique of using what is called dope to cover the aircraft on a test piece and despite the good results the product earns its name for a reason. With strong fumes and less forgiving then the non-toxic glue stick and Krylon spray, the choice was not hard to make.